Füller Glastechnologie Vertriebs-GmbH

The blowing machine is designed to produce glass items with a wide range of simple and complex shapes: narrow-necked, bulbous, tapered, thin-walled, thick-walled (for cutting), high, slim and wide as well as stemware with no seams. It has been developed to achieve highest quality requirements and to provide highly flexible production conditions.

The pressing manufacturing mode is designed to produce glass items with d�cor and with a wide range of simple and complex shapes. The pressing system may be combined with gob feeding and continuous casting (in combination with the horizontal movement of the telescope unit and the vertical movement of the lower servo-motor system). It is also compatible with every mould system available (block mould, basket mould, hinge mould).

The injection manufacturing mode is designed to produce (heavy) glass items with d�cor and items with a wide range of simple, complex and especially slender shapes..

The roundtable is equipped with 2 to 20 stations. The servo-driven table allows to run production on varying numbers of stations for varying capacities. The injection mould and closing device for hinge moulds are mounted onto the roundtable while the press reservoir is precisely positioned underneath the roundtable. The horizontal stroke of the roundtable allows to move the injection station underneath the orifice of the feeder, where the press reservoir is fed with a precisely defined quantity of glass. After moving out of the feeding position, the mould is closed and clamped and the lower pressing unit injects the glass out of the press reservoir into the injection mould. As an alternative to gob-feeding, a gob-transfer equipment allows continuously casting a precisely defined quantity of glass into a casting mould, which moves the glass from underneath the orifice of the feeder to the roundtable, where the glass is filled into the press reservoir.
The roundtable injection press is equipped with two servo-motor pressing units: the lower pressing unit for injecting and the upper pressing unit which holds the mould, the plunger for vases or a nose piece for pressing a thorn (e.g. hole for candleholders). The lower servo-motor pressing unit is equipped with a sensor, which reduces the pressing pressure to a holding pressure as soon as the item is sufficiently pressed and the pneumatic after-pressing is started, which compensates for shrinkages in the cooling glass item. The mould is opened as soon as the glass item is sufficiently cooled and is taken out by hand or fully automatically.